Shogun Steering: Ackermann plate - toe out and camber

[Horatio]

Hi, the spring from AliExpress finally arrived. I have a question: when you installed it, did you preload the spring to the max or not?

No! Preload it some. Be careful not to cross thread the preload collar. You have to press the spring down while you get it to tighten. Leave 2 or 3 threads visible.

 

[Horatio]

Like this.

 

[Nelson.81]

Hi, the spring from AliExpress finally arrived. I have a question: when you installed it, did you preload the spring to the max or not?

Not the max but did tighten it up quite a bit left enough for the spring to compress a bit.

 

[Opua]

View attachment 13267View attachment 13266
Like this.

Perfect, thank you

 

[Opua]

Not the max but did tighten it up quite a bit left enough for the spring to compress a bit.

View attachment 13268

Since it's very stiff to tighten, I'm afraid of stripping the threads; do you think this will work? I'm tightening it with pliers, and it's really hard to turn.

 

[Nelson.81]

Since it's very stiff to tighten, I'm afraid of stripping the threads; do you think this will work? I'm tightening it with pliers, and it's really hard to turn.

View attachment 13271

Probably because it’s so dirty lol they are a bit stiff but shouldn’t cause that much issue to tighten I would take it apart give it a good clean & degrease see it makes it easier. But you could try it like that see how it feels for you.