chipster
Well-known member
- Messages
- 86
- Reaction score
- 61
Since new my Python has always had a few degrees of toe in. I looked at the instructions which describes adjusting the turnbuckles! My V2 Python doesn’t have any. Due to this it was pulling left. So I moved the servo arm one tooth but that sent it pulling to the right. Back to the start. So I adjusted the turnbuckle on the link arm. This didn’t really help. I don’t want to buy the turnbuckles for the toe adjustment as this may weaken the Python. Is there an alternative way to adjust toe. Moving to a different hole on the Ackerman plate maybe. Or changing the camber spacers. Help!! I just want it to drive in a straight line without making constant changes to the trim settings.
Thanks
Thanks