Torox 185 programming

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
BashingBrian said:
That's so weird because my blue one will just not work with the T185, it doesn't even light up 🤪🤔
Click to expand...
I feel bad for asking but you are using it at the esc fan connector? Not reversing polarity? I only ask because I have plugged my card in with polarity reversed😁 wtf!? Why this no workie🤪🤣🤣
 
@Mazin , @KnowAir or anyone else.

Would you mind running through your preferred settings for these items?
For reference, I'll be running the Torox 185 on 6s in an XTR.


3) LVC
4) ESC Thermal
5) Motor Thermal
6) Motor Rotation (assuming CW)
7) BEC Voltage
8) Max Brake (any preference?)
9) Punch
10) Drag brake (assuming zero since it's not a rock crawler)
 
doolin64 said:
@Mazin , @KnowAir or anyone else.

Would you mind running through your preferred settings for these items?
For reference, I'll be running the Torox 185 on 6s in an XTR.


3) LVC
4) ESC Thermal
5) Motor Thermal
6) Motor Rotation (assuming CW)
7) BEC Voltage
8) Max Brake (any preference?)
9) Punch
10) Drag brake (assuming zero since it's not a rock crawler)
Click to expand...

What happened to 1 & 2 :LOL:
3. I would leave it at intermediate.
4. Leave it on the factory setting.
5. Turn it on to setting 2.
6. Leave it factory.
7. If you have a high voltage servo set it to 7.4v if you are unsure leave it at 6.0.
8. This is something that you will have to mess around with yourself and find a setting that best suits the way you drive.
9. Start out with the stock setting then work your way up to 5.
10. Leave this at zero otherwise you will nose dive off every jump.
 
doolin64 said:
@Mazin , @KnowAir or anyone else.

Would you mind running through your preferred settings for these items?
For reference, I'll be running the Torox 185 on 6s in an XTR.


3) LVC
4) ESC Thermal
5) Motor Thermal
6) Motor Rotation (assuming CW)
7) BEC Voltage
8) Max Brake (any preference?)
9) Punch
10) Drag brake (assuming zero since it's not a rock crawler)
Click to expand...
Left all thermal settings factory same for BEC
Brake I turned up to 75% but I think that will go back to 62.5%
Punch on the sketer I turned to 5 on the shogun I turned down to 2 (wife wanted softer starts.
Didn't use drag brake
 
I know this post is late to the party, but I just want to share that I was able to use a Hobbywing Crawler 540 Series programmer (with a red stripe on the face) to successfully program the Torox 185 ESC in my Radix6. I just used the settings in the manual and ignored what is shown on the programmer. I used the 540 Series programmer to up the BEC voltage from 6.0V to 7.4V after I found out the stock Corally Varioprop 7225 servo was designed to run at 7.4V to get the full 25kg of torque at .13 seconds.
 
Back
Top