TORQ MASTER

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

HomeHere

Well-known member
Messages
142
Reaction score
202
Points
198
So, while browsing the team corally site for parts (I love ordering parts!(Not paying for them 😭).).
I decided to buy -
20250519_152042.webp

20250519_152106.webp

Very excited to try this out on my next wrenching session! (Less wrenching hopefully).

Also, ordered last Monday, arrived today!
7 days to Australia.
So happy.
....
On another note no lollies this time 😭.
 
I can’t imagine going back to non-electric screw drivers to complement the ‘manual labor’ screw drivers😉.
I actually got two electric ones, in one I put a 2.0mm speed tips and in the other 2.5mm😂.
😂
My son said the same thing,
"ya need 1 for each bit so ya don't have to swap em."
 
So, while browsing the team corally site for parts (I love ordering parts!(Not paying for them 😭).).
I decided to buy -
View attachment 9312
View attachment 9313
Very excited to try this out on my next wrenching session! (Less wrenching hopefully).

Also, ordered last Monday, arrived today!
7 days to Australia.
So happy.
....
On another note no lollies this time 😭.
It's very very nice, loads of power and quality 👌 I have one for back up for my imrc driver.
The tips are good, not mip good, but good.
 
Corally should have gone with the Worx WX242L which has an adjustable cutoff clutch. At it's weakest setting you can trip it with your fingers so it's very good for working on RC stuff and won't just strip plastics when set to the lowest setting (still need to hand tighten a little more though)
 
Corally should have gone with the Worx WX242L which has an adjustable cutoff clutch. At it's weakest setting you can trip it with your fingers so it's very good for working on RC stuff and won't just strip plastics when set to the lowest setting (still need to hand tighten a little more though)
Yeah, it's got some power I bearly use it. Most of the time I use the I'm rc driver, when using the torque master I only have it on low
 
I can’t imagine going back to non-electric screw drivers to complement the ‘manual labor’ screw drivers😉.
I actually got two electric ones, in one I put a 2.0mm speed tips and in the other 2.5mm😂.
They should just use 2 and 2.5 for entire build and be done with it
 
Back
Top