Spark Spark xb6 turnbuckles

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Dust1986

Dust1986

Active member
Messages
10
Reaction score
2
Points
38
Hello, in the end between the Synchro 4 and the Spark I chose the Spark. However, I noticed that the turnbuckles are missing, both front and rear, to adjust the toe. Could you please list the parts I need to buy to make the upgrade?





Thank you.
 
These

IMG_9832.webp


IMG_9833.webp


IMG_9834.webp
 
Plenty have , with it and the older radix/python their sbx825 kit based on same chassis design. I have older buggy python don’t race
 
From the specifications, you can see that the ride height is a bit high. What can I do to bring it to 28 mm at the front and 29 mm at the rear?
 
Can you tell me what the ground clearance is right out of the box? Is it possible to get it down to around 28/29 mm?”
 
I unscrewed the shock collars and the car lowered. I’m now at 33 mm in the front and 38 mm in the rear. I believe the only solution is to install slightly softer springs. Do you know which springs come stock? Do you have any springs to suggest?
 
Dust1986 said:
How much can I lower it by tightening those screws? They seem very short to me.
Click to expand...
It’d be quicker to try than write a post asking lol. Can get longer grub screws even titanium ones but a few turns on the inside =bigger movement on the outside. Think they come with medium springs but check manual you’ll find the specs shouldn’t be hard to work it out.
 
Going back to the turnbuckles: are there any cheaper alternatives to the stock ones? Honestly, €60 for just a few parts seems a bit excessive to me. Has anyone found compatible alternatives?
Thanks
 
Back
Top