Kronos Heat sink and fan…

[Newkronosuser2709]

Tried to add a power hobby dual turbo fans on my Kronos motor installed it and when I tried to wire it up to my receiver box there was an open Chanel and it was labeled bat. Then Chanel 1 and chan 2. Am I able to wire it up to the free Chanel or do I have to run separate power for the fans? Please any input will be taken into consideration. Thanks

 

[morrjr71]

Plugging the fan connector into a free channel on the receiver should work for those fans.

 

[norcalsc]

the Rx should work with no issues

 

[Newkronosuser2709]

Plugging the fan connector into a free channel on the receiver should work for those fans.

Tried that but the receiver seems to have only 2 channels. The varioprop remote and receiver when I opened the receiver box only has Chan1
Batt
Chan1
Chan2 I tried plugging into the batt section and it didn’t work. So would I have to buy a new remote and receiver with 3 channels or just run a small battery for that and plug into the batt Chanel??

 

[Spoon]

On my Sketer I bought a splitter cable and took out the connector of the esc fan, connected the esc fan and motor fan to the splitter so the esc will power both.

 

[Newkronosuser2709]

On my Sketer I bought a splitter cable and took out the connector of the esc fan, connected the esc fan and motor fan to the splitter so the esc will power both.

Do you have a specific splitter for that esc

 

[morrjr71]

Tried that but the receiver seems to have only 2 channels. The varioprop remote and receiver when I opened the receiver box only has Chan1
Batt
Chan1
Chan2 I tried plugging into the batt section and it didn’t work. So would I have to buy a new remote and receiver with 3 channels or just run a small battery for that and plug into the batt Chanel??

The radio and receiver set that comes with the Corally vehicles is very basic, so it wouldn't be a bad idea to replace it. You can get a transmitter/receiver set that has five or six channels and a lot of functions for around $80. I have a Radiolink RC6GS radio for my Radix6: the same transmitter controls three other vehicles, and can control up to seven more. The link below is for the V2 version: the V3 version costs a bit more

https://www.amazon.com/Radiolink-Tr...11664214&keywords=rc6gs&qid=1659962633&sr=8-6

 

[Spoon]

Do you have a specific splitter for that esc

I ordered something like this.

 

[morrjr71]

Do you have a specific splitter for that esc

The Corally ESC uses a standard 3 pin connector, so any splitter with that connector should work.

https://www.amazon.com/Spektrum-Fut...jbGlja1JlZGlyZWN0JmRvTm90TG9nQ2xpY2s9dHJ1ZQ==