Kagama The Troll that can't leave anything alone, Punsher 4.

That's not just a new screw in my chassis, it's a new screw hole. My ESC plate flaps up and down no more. I also installed three 3x6x4mm spacers in-between my ESC plate and the battery box to raise it above the feet of the rear tripod brace. The third spacer is CA glued to the bottom of the ESC plate chassis mount (the one my new screw mounts to). The ESC plate sits 1mm higher than the foot of the tripod brace. Everything fits perfect.

While I was at it I also installed a new ADU Kagama 6s motor mount. It fit perfectly with no modification to the truck.
The fan on the motor made a really big difference. Last drive I overheated the motor with a 14t pinion. This drive I ran a 16t and the motor only got mildly warm.

I've got ADU hinge pin retainers and Corally Asuga adjustible steering links on order. I'll post about them when they're installed and tested.

And yes, I know my truck needs a bath.

I never use golden screws that come with the ADU parts, they feel a bit weak if you ask me

Rotauq said:

I never use golden screws that come with the ADU parts, they feel a bit weak if you ask me

Click to expand...

Dat valt reuze mee.

I have more gold screws on my truck, the hinge pin retainers are installed. I'm going to have more gold screws too. I ordered an aluminum gearbox for the rear.

Hinge pin retainers.
My only complaint with the stock ones is the hinge pin holes deform. As far as strength goes I have no complaints.

4 changes turned it from an OK truck into my favorite truck.

Asuga a-arms, links, and driveshafts. Making the truck wider drastically changed its personality for the better.
Upgrade Corally aluminum shocks. I run 70wt fluid in them.
Slightly larger wheels. Arrma 4s Backflips with 6mm offset hexes. When adjusted for wheel dish the offset is closer to 2mm.
Stiffer servo saver spring.

I've made other changes to the truck as well, but the list above is the foundation everything else sits on.
I'm very happy with how the truck drives.