BrettOlbrys
Well-known member
Good morning. It appears there was a sharp piece of the chassis that has punctured the wiring on my Torox 185. It is the wiring leading to the on/off switch and it's roughly halfway between the controller and the receiver.
It didn't appear to be hurting the operation of my XTR, so should I leave it along and wrap it with electrical tape OR cut that small piece out and solder the wires?
Thanks
Brett
It didn't appear to be hurting the operation of my XTR, so should I leave it along and wrap it with electrical tape OR cut that small piece out and solder the wires?
Thanks
Brett